ELCSQ16
- Nominal size：
- 16mm
- Lead：
- 2mm,5mm,10mm
- Stroke length：
- 30mm,50mm,75mm,100mm
- Product Overview
- Model Specification
- Product File Download
Characteristics of electric cylinder:
I Easy to use
1. It can be used through simple wiring, and can be operated with 24V DC power and switch signals.
2. With built-in torque return function, no sensor installation is required (as shown in the right figure).
3. It can easily set multiple points for positioning.
4. It allows for simple setting of thrust and operating speed.
5. Multi-axis operation can be achieved through various buses.
6. Compared to traditional cylinders, it eliminates the need for pneumatic components, thus eliminating the concerns of air leaks and maintenance.
II environment protection
1. No air source is required, significantly reducing power consumption.
2. No need for exhaust, low noise, and no odor.
III high performance
1. Simple structure, no maintenance required! Capable of long-term operation.
2. It has no wear parts and is not affected by external environment. Under rated load, its service life can be predicted.
IV high precision
Utilizing high-precision ball screws and T-shaped screws, the positioning accuracy can reach ±0.01 (ball screws) and ±0.05 (T-shaped screws). The motor part employs closed-loop stepper motors or servo motors with encoders, ensuring high precision and minimal step loss.
Notes:
1. Please use the sliding table within the rated load range: Please select the model based on the MAX handling weight and allowable torque. Overloading may cause gaps in the guide rail and affect accuracy.
2. Do not use under conditions where excessive external force or impact is applied: it may cause the slide table to malfunction.
3. Except when returning to the original point, do not collide with the end of the travel range: If the sliding table collides with the end of the travel range, it may damage the guide rails, bearings, internal limits, etc., preventing normal operation. When used vertically, the sliding table may also collide with the end of the travel range due to the self-weight of the workpiece causing it to fall, so attention should also be paid to this.
4. The parallelism of the installation surface should be below 0.02: If the parallelism of the surface on which the sliding table is installed is poor, it will cause deformation of the sliding table installation surface, affecting the accuracy of the guide rail and the smoothness of the sliding motion.
5. Please use side-mounted brackets when installing the sliding table at a non-horizontal angle: only for direct-connected ceiling installation
6. Do not use the sliding table by hanging it: Using it by hanging can cause malfunctions, abnormal noises, increased deformation, etc.
7. When installing the sliding table, please use screws of appropriate length and tighten them within the MAX tightening torque range. Exceeding the MAX tightening torque value may cause poor movement of the sliding table, while insufficient tightening may lead to sliding table deviation or falling off. Please take note.
